Show config port name statistics - Statistics of the port: total bits/frames passed, maximum/minimum bits/sec seen, and most interesting - CRC errors, error frames, oversize frames, discards.Ĭonfig port name - Show port utilization in bits/sec in real-time Show config port name status - Show port status: administrative and operational states, speed/duplex, connector type, MAC address, and most important (for fiber) - RX/TX signal power (dBm). Show configure port summary - Show port summary: state (up/down), speed. I show examples of using them below as well. The commands below are meant to be run on the device CLI itself, not on provisioning system (RadView etc) of some kind. This post, I hope, comes to fill the gap. And while reference documentation is available, I couldn't find the debug/information commands digest on the Internet at all. ![]() ![]() Carrier Ethernet Devices by RAD (ETX-203AX, ETX-203AM, ETX-203AX-T, ETX-205A, ETX-220A) are quite popular with telco companies around the world for connecting end clients to the backbone at layer 2.
0 Comments
Leave a Reply. |